EDIT: Image and link have been updated to latest version. Getting close to sending the files off to Ponoko and trying it out.
Statistics: Posted by ecurtz — Mon Jan 26, 2015 6:03 pm
]]>
Statistics: Posted by ecurtz — Mon Jan 26, 2015 5:55 pm
]]>
]]>
]]>
]]>
]]>
Statistics: Posted by ecurtz — Thu Jan 08, 2015 7:32 pm
]]>
]]>
]]>
]]>
Statistics: Posted by ecurtz — Sat Aug 23, 2014 12:19 pm
]]>
Printed parts: I know it's nice to get exactly what you want at low cost, but it seems like those will be the bulk of the time producing kits. As I mentioned in the Kickstarter comments many of these could probably be replaced with off the shelf stuff, perhaps leveraging parts from open CNC or filament printer builds.
Tilt: If the tilt design was reversed so that it pulled down the back edge of the build plate rather than lifted would this mean the main axis would only need to move up and backlash could be eliminated?
Build area: I may have goofed the math, but I'm not sure the petri dish is large enough for the build area listed for the P1500. It seems a pity to waste potential resolution or build area.
Statistics: Posted by ecurtz — Mon Aug 18, 2014 4:19 pm
]]>