Statistics: Posted by Wonderdog — Thu Jul 16, 2015 6:26 pm
]]>
As for 25micron and lower print times, generally halving the layer height you can go down 10-25% in layer time, and as you get lower that percentage may need to increase as a function of the pigment level giving diminishing returns. Too much cure time on lower layer heights will end up inflating the print and losing some detail.
Statistics: Posted by goopyplastic — Wed Jan 14, 2015 3:25 pm
]]>
]]>
]]>
Statistics: Posted by deadmeat30 — Tue Jan 13, 2015 9:28 pm
]]>
]]>
]]>
It looks like you are losing the prints when you are transitioning from the base to the layer cure times, so a longer layer cure will help. Also make sure the PDMS isn't fogged (damaged), fogged PDMS will lose much of its nonstick properties.
SubSF in particular will suffer from printing problems between the base and layer transition in the layer cure time isn't long enough. Some prints this is more noticeable. I have talked to CW creator to add in an option to feather the base to layer time transition but don't think it's available yet however a longer cure time will generally fix this. Feathering the transition would allow you to run at a lower cure time though which would help with increased detail and pdms life.
You said it is a balance, that is the best word I can use to describe it. We are trying to get the lowest cure time that results in the model fully forming. Any extra cure time that isn't needed will cause more bleeding and reduce pdms life.
Statistics: Posted by goopyplastic — Tue Jan 13, 2015 3:24 pm
]]>
Statistics: Posted by deadmeat30 — Tue Jan 13, 2015 1:58 pm
]]>
b9 creator software i find very usefull and meshmixer.
cheers,
hp
Statistics: Posted by hp_ — Tue Jan 13, 2015 2:06 am
]]>
Whats the best program for support creation?
Statistics: Posted by deadmeat30 — Mon Jan 12, 2015 8:03 pm
]]>
]]>
]]>
Here is how i have been getting on (I should of kept a record of each base/layer time DOH!!)
Statistics: Posted by deadmeat30 — Mon Jan 12, 2015 3:07 pm
]]>
http://www.littlerp.com/?page_id=55
and probably some on Thingiverse, etc.
Statistics: Posted by Scatterplot — Mon Jan 12, 2015 2:37 pm
]]>