]]>
I'm looking for success stories from other DLP-based printers other than the B9Creator.
Statistics: Posted by rkundla — Sun Oct 04, 2015 5:15 pm
]]>
Hinging the hood would be good - 4 bar linkage either side for example. That would get around the issue of laying the thing down every time. SBC - not so worried. I could print a cover for the existing one which would do just as well, I like the OTS nature of what you've used. Other than that? It'd be nice to have a way of dismounting the projector from the top; I know there's the magnet setup for the mounts, but I'm not sure about the reliability on alignment when it's reattached. Maybe a separable carrier? Doesn't need optical bench precision, but has to get the distance accurate (?!) to maintain print size tolerances.
Statistics: Posted by ps_bond — Fri Sep 04, 2015 3:54 am
]]>
I think Acer is really hard to come by in Asia so we see different brands.
I should have support for the ViewSonic PJD5232 soon and will look at buying a few 1080p projectors to get some solutions for them as well, possibly an infocus, viewsonic, and vivitek. If people have come up with solutions for other projectors I could provide a bounty / reward for documenting it.
Statistics: Posted by goopyplastic — Wed Sep 02, 2015 4:59 pm
]]>
Usually I'm printing small jewellery items as one-offs, so invariably at the centre of the image - as such I haven't seen the problems with evenness.
TBH I'm a little surprised at how quiet users of the LittleRP have been. One of the things I enthused about as a Kickstarter was the opportunity for the open source community to get access to a semi-commercial printer (as opposed to going the whole hog & building from scratch); I'd hoped this would lead to more interchange of information & mutual support, but there seems to be a fairly small number of people who are actually trying to use the unit beyond the resins supplied with it. IMO, of course - it's entirely subjective.
Statistics: Posted by ps_bond — Wed Sep 02, 2015 3:59 am
]]>
]]>
]]>
]]>
However... One of my issues may be the use of the flex vat - trying to grow the base layers thick to compensate for the vat base bending away. I shall test. ATM it's just the cal block I'm trying to print, but I want to get it to the point of printing half a dozen rings at once - so it'll be a larger baseplate.
Statistics: Posted by ps_bond — Fri Aug 28, 2015 7:09 am
]]>
]]>
Statistics: Posted by ps_bond — Thu Aug 27, 2015 2:34 pm
]]>