Build Your Own SLA/SLS

I have problem with the printer. The seller said " The software works with the LCD light. I told you use this software and dry run the printer. Then it works. " But there isn't image on LCD during printing. https://www.youtube.com/watch?v=kNJ_QeF9aY8 Do I understand correctly the problem ...

Thank you malamen! The motor works fine and no more noises. But the prints still don't stick to the platform.. Check out the picture, the resolution is perfect and the LCD works fine too. It must be wrong leveling, don't you think? Is it better to be too close to the lcd than too far away? This time...

I think it's a leveling problem on my end. Is it possible that the prints tend to stick to the FEP when it's still a little sticky from the last print?
I tried to print the Rook Tower but it got stuck to the FEP. At some point it must have floated away because there are two footprints.

Hello! Since i believe that my lcd and the rest of the printer works fine, do you guys think my failed print (picture in my earlier posts) is due to bad leveling? Or is there another possible reason? I manually positioned the platform close to the lcd without the tray and adjusted the four screws in...

There you go! I also wanted to upload the picture for everyone else to see, because i need to know if it looks fine or if there is something wrong with the display.

i have the same problem. Because there is no signal on display .And you should try to to save file and only after that slice it So it's a defective board then? I did save the file before slicing. Thank you for your replies! Yeah, the platform did seem to be stuck.. The motor was noticeably noisy an...

Hello guys. My first attempt to print was a failure - it seems the entire build plate was cured. Check out the picture. I did a dry run without the tray and no resin and the leds were flickering. Is this normal? I wanted to give it another try but i cannot connect to the printer through the browser ...

Nevermind, everything is explained in the video. Sorry for dumb-spamming.

Dr. Woo, oops yeah you're absolutely right - for some reason i thought the leveling was done by the glass on the build plate much like a heated bed on an fdm-machine. But still, does it make sense not to have the glass? Does anyone of you have a link to the manual with the raspberry pi version so i ...