Build Your Own SLA/SLS

Thanks again.

I just had a quick view on the CW, It gives me choice to use any Motor, Like XY or Extruder.

But Im not so sure, how the firmware will understand that Extruder Motor is being used for Tilt mechanism.

Thanks a lot Adambx. How do you configure the extruder drivers in CW to work in sync with the Z drive. I was also confused how that sync in tilting happen's. Does Creator Workshop has setting that will send those signals, which can be used to drive the motor. Im sure, that Z axis movements and preci...

Hello All, Im building a DLP printer, while, I see the importance of the tilt mechanism here. I would like to get clarified for the below doubt, Please guide How does the tilt motor gets controlled by the software, assuming Im using the RAMPS kit, where do I connect the TILT motor, Do I need some Ca...