Build Your Own SLA/SLS

Hello guys, I've brought a used scanner with flexscan3d ver 3.17 software that comes with 2 1.3mp camera and a acer projector Everything works fine except the scanned data have wrong size, calibration score at 80% and above. I tried scan with the 10mm calibration board and the output data was 8mm on...

Hey seasick How you mount your camera ? at exact 35 degree ? I do a lot of scan today with the 20mm calibration board , I just found out that the wider the angle of the two camer the smaller output it gets( on east-west side ), the more narrow , the bigger number, I didn't do any marking on my mount...

hello seasick

on the ballbar tuning , do i input the lenght of the bar or the diameter of the ball ？
thx man

alex

Seasick YEa, that was me , I've been trirping on the net and couldn't found anybody have post anyting like that, Thanks !!! I'll try look into it again tonight when I get back. On the ball tune, is that mean we place a ball that have a diameter of 5cm and if the scanner couldn't read 5cm then we tel...

BTW, I was the one asking question on you tube as well.. so you don't need to reply in both place

Hello Seasick

Thanks again for your reply .
I'm currenty using 3.17 , and I didn't see the ballbar tuning in the software, where is it at ?
What version you're using ?
Thanks

Alex

Hello seasick Thanks for your reply , I'm not sure if both of my cameras are having the same firmware , how do I check ? I place the scanner about 40cm apart, left-right 20cm form the projector lens , scanning object is about 50cm far, that's too close ? the calibration went fine, the object looks p...

Hello sir I've just build my own scanner too , by using two pointgrey 1.3MP camera and a acer projector Everything works well and the calibration have 84-85% average . How every the scan result was bad, the size was 0.6mm off all the way around, what do you think the problem is ? Also I would like t...