Page 1 of 1
how big can the object be..?
Posted: Fri Feb 07, 2014 6:35 am
by mandy
.. i only can se small objekt like 2x2x2cm to maybe 10x10x10, is it possible to print out larger objects like 30x30x30 or even bigger if the vat can contain that volume of resin?
thanks for reply.
Re: how big can the object be..?
Posted: Fri Feb 07, 2014 8:36 am
by PacManFan
There isn't a limit to how big an object can be in Creation workshop. You'll just need to set up the build area correctly.
Re: how big can the object be..?
Posted: Tue May 27, 2014 5:35 pm
by Excited4DLP
Is it even physically possible to print something as big as 12" x 12" with a DLP/SLA printer seeing that the Van Der Waal force is almost 200lbs with a 7.5" x 4.25" build plate?
Re: how big can the object be..?
Posted: Tue May 27, 2014 9:17 pm
by Finhead
Re: how big can the object be..?
Posted: Wed May 28, 2014 3:28 pm
by Excited4DLP
Re: how big can the object be..?
Posted: Wed May 28, 2014 6:17 pm
by Finhead
Re: how big can the object be..?
Posted: Wed May 28, 2014 11:33 pm
by Excited4DLP
I noticed that the Titan 1 from Kudo uses some sort of flexible material for their VAT while allows the entire VAT to "peel" from the build plate when the Z-axis moves upward. What type of material is flexible that is also thick enough to be used as a VAT that lets UV light pass through?