Build Your Own SLA/SLS

I recently interviewed with Michael and Chris from the 'All Things 3d' podcast site.

Very cool Steve, you sound like a busy boy with all the companies your software is tied to now. And awesome you are getting some payback for all the hard work you put into the software. And I agree with there comments about it being very polished, out of all the slicers I have used for FDM printing this is far more refined and easier to use IMO.

You touched on a few options I still had yet to explore in CW, if you don't mind me asking.

Is the CWS file now able to be saved off after slicing etc or just plating with supports and then opened on another PC for printing? I have a slower dedicated PC running the printer and would be great to slice up and have it all ready on my main PC.

Going to post this and continue in the software section as to not derail the point of this post.