CW Bug - Lifts before Exposure ends
Posted: Wed Jun 11, 2014 6:38 pm
Anyone else running into issues where the lift sequence starts before the end of an exposure?
Build Your Own SLA/SLS
A forum dedicated to helping you build your own SLA/SLS-based 3d printer
http://buildyourownsla.com/forum/
CW Bug - Lifts before Exposure ends
Page 1 of 1
Re: CW Bug - Lifts before Exposure ends
Posted: Wed Jun 11, 2014 9:33 pm
I'm looking into it. You can insert a short delay of 250-500 ms after the exposure before the lift to compensate for it. Should be fixed next version.
Re: CW Bug - Lifts before Exposure ends
Posted: Tue Jun 17, 2014 2:17 am
Look here 
Re: CW Bug - Lifts before Exposure ends
Posted: Sat Jun 28, 2014 2:02 pm
is there any advantage in letting the layer "sit" for a couple of ms after exposure just befor before lift? Or is it ok to start the lift right after exposure is finished?
Cheers!
Cheers!
Re: CW Bug - Lifts before Exposure ends
Posted: Mon Jun 30, 2014 1:25 pm
I had this happen to me as well. Restarting CW fixed it tho. 
Re: CW Bug - Lifts before Exposure ends
Posted: Mon Jul 14, 2014 4:45 pm
Could it be an issue with showing slices in 3D while printing large polycount models? I can't prove it but my gut says it seems to contribute.
Re: CW Bug - Lifts before Exposure ends
Posted: Thu Jul 31, 2014 10:43 am
I solve it with 8 M400, this command forces marlin to finish all command, and then Marlin can start with other command.. You must use 8 command to fill the buffer !
Re: CW Bug - Lifts before Exposure ends
Posted: Thu Jul 31, 2014 11:45 am