Build Your Own SLA/SLS

Hi to all,

First a big thank you to PacManFan for writing this nice piece of software an making it open source!

I have created two projector commands to switch the projectors on and off in a dual projector configuration.
projector_on
projector_off
Those are working fine from the control pane.

Now, what would the syntax be to insert them in the gcode header and footer?

Thanks in advance!

The following will send the projector command to all attached projectors. You can use it anywhere gcode appears.

;<DispCmd> ALL,projector_on

That works like a charm.
Thanks.