grbl firmware

[vonhellsing]

Its alive master!!!! it's alive!!!

BUT!! kkk my motor just make noise and don't move nice, if i use comand G0 X0 Y0 Z5 they spining for both sides, 1to up 1 to down, 1to up 1 to down,

i configure my Pololu A4988 Stepper Driver with .40V and Sixteenth step on GBRL
my step motor


i using M5 leadscrew.


cheers!

Angelini

[PacManFan]

You may have a wire of your A/B phase switched around. Double check the motor wiring

[vonhellsing]

hi packman,

i change stepmotor and works fine, now i fight with creation workshop kkk

eg. i draw a 40mmx40mmx40mm box and in projection stay really big than original.
thx per help soon i'll make on topic with my droplit mod.

cheers!


angelini

[PacManFan]