Smooth surface pan paper
Posted: Sun May 18, 2014 6:32 am
Hi all,
New to the forum and SLA 3d printing. Have been churning through the posts over the weekend sucking up as much info as possible! So to my question, in the FAQ post:
viewtopic.php?f=11&t=17
A paper (Pan, 2011) is linked to describing a technique to achieve smooth surfaces using a greyscale effect on the slices and also using the surface tension of the resin. I was wondering if this technique is actually used by anyone? Has anyone got any experience with it and does it truly improve performance?
Cheers,
Ben
New to the forum and SLA 3d printing. Have been churning through the posts over the weekend sucking up as much info as possible! So to my question, in the FAQ post:
viewtopic.php?f=11&t=17
A paper (Pan, 2011) is linked to describing a technique to achieve smooth surfaces using a greyscale effect on the slices and also using the surface tension of the resin. I was wondering if this technique is actually used by anyone? Has anyone got any experience with it and does it truly improve performance?
Cheers,
Ben