Build Your Own SLA/SLS

I'm a complete newb when it comes to SLA printing, so I'm glad to find this board. I'm looking to make prints for investment casting and I'm hoping some of you out there have some recent experience with some of the casting resins.

Thus far I've been recommended the b9-1 Red. Does anyone have experience with that resin, or with the Firecast from Madesolid, or the Form1 Castable resin? This would be for jewelry level detail and casting. I'm using a Muve-DLP.

Also, I haven't yet come across any "sla 101" as far as post build cleanup, cure times, use a UV oven or not, etc.

Thanks!

Hi chinman,

there are a few more castable resins out there.

Funtodo Castable looks also like it is working very well

cheers,
hp

There are a number of posts about this on the b9 creator forums with details about burn out temps and times